|
Main
Home
Contact Info
Equipment
Barges
Tugs
Odds n Ends
Past Photos / Jobs
Move this Old House
PCL Bridge Dismantling
Equipment
DANATUGS Salvage of Cargo Plane
Cape Canaveral Reef Project part 1
|
On board battery pack or have a well-ventilated compartment near the engine or directly into the engine compartment.
Next to the tank or in the same room with the batteries installed are not allowed.
The main consumers of electricity are: Ignition engine; group of devices that control the mode of its operation; starter, running lights and the lights, a visual signal, audible alarm, lighting facilities boats, powerful automobile headlamp illumination to the shore and the deck of the vessel at mooring.
Control devices and engine management systems, fuses and circuit breakers are mounted on a common distribution board. The panel is made of fire-resistant panel and a durable insulating material or metal. All open conductive parts of electrical equipment mounted on the inner side of the panel.
. Fuses and circuit breakers can be replaced by a single machine, which also turns off the power grid in case of short circuit or overload.
On small boats to power each device is recommended to serve on two wires, even if the metal hull of the vessel. When wiring them try to place on the same board, where the junction box is installed and unite in a common bundle, which are wrapped with a cloth and covered with special insulating varnish. Tourniquet is attached to the hull structures (usually a fender) with brackets and cable ties & attendance, which put a 250-300 mm. Wires need to cut and mark. For laying the network can also use aluminum tubing or flexible metal hoses.
Most suitable for boat wiring stranded cables.
Aluminium wires for boats and yachts are not recommended, since they are prone to corrosion in high humidity on copper and steel contacts. To reduce the voltage drop in the wiring to the lamps running lights and interior lighting it needs to carry out the copper wire diameter of 1.2-2 mm |
|